SI-3006KWM datasheet(6/9 Pages) ALLEGRO

部品番号	SI-3006KWM

部品情報	1 A, Low-Dropout, Dual Output, 1.8 V & 3.3 V Regulator

Download	9 Pages

Scroll/Zoom	100%

メーカー	ALLEGRO [Allegro MicroSystems]

ホームページ	http://www.allegromicro.com

Logo

6 / 9 page

SI-3006KWM

1 A, Low-Dropout,

Dual Output,

1.8 V & 3.3 V Regulator

115 Northeast Cutoff, Box 15036

Worcester, Massachusetts 01615-0036

Linear

Regulators

6

Input Capacitor (C

I, 0.1 ∼ 10 µF). This is necessary

either when the input line includes inductance or when the

wiring is long.

Output Capacitor (C

O, >22 µF). This device is not

designed for a use with a very low ESR output capacitor

such as a ceramic capacitor. Output oscillation may occur

with that kind of capacitor.

ENABLE Input. The ENABLE (control) input features

an internal pull-up resistor. Leaving this input open causes

the output to turn on.

Parallel Operation. Parallel operation to increase load

current is not permitted.

Determination of DC Input Voltage. The minimum

input voltage V

I(min) should be higher than the sum of the

fixed output voltage and the maximum rated dropout

voltage.

Overcurrent Protection. The SI-3000KWM series has

a built-in fold-back type overcurrent protection circuit,

which limits the output current at a start-up mode. It thus

cannot be used in applications that require current at the

start-up mode such as:

(1) constant-current load,

(2) power supply with positive and negative outputs to

common load (a center-tap type power supply), or

(3) raising the output voltage by putting a diode or a

resistor between the device ground and system ground.

Thermal Protection. Circuitry turns off the pass

transistor when the junction temperature rises above 135°C.

It is intended only to protect the device from failures due to

excessive junction temperatures and should not imply that

output short circuits or continuous overloads are permitted.

APPLICATIONS INFORMATION

Heat Radiation and Reliability. The reliability of the

IC is directly related to the junction temperature (T

J) in its

operation. Accordingly, careful consideration should be

given to heat dissipation.

The inner frame on which the integrated circuit is mounted

is connected to the GND terminal (pin 3). Therefore, it is

very effective for heat radiation to enlarge the copper area

that is connected to the GND terminal. The graph illus-

trates the effect of the copper area on the junction-to-

ambient thermal resistance (RθJA).

The junction temperature (T

J) can be determined from

either of the following equations:

T

J = (PD × R

θJA) + TA

or

T

J = (PD × R

θJT) + TT

where P

D = IO1(VI – VO1) + IO2(VI – VO2) and

RθJT = 6°C/W.

同様の部品番号 - SI-3006KWM

メーカー	部品番号	データシート	部品情報
Allegro MicroSystems	SI-3006KWD	441Kb / 9P	1A, Low-Dropout, Dual Output, 1.8V & 3.3V Regulator
Allegro MicroSystems	SI-3006KWD-TL	441Kb / 9P	1A, Low-Dropout, Dual Output, 1.8V & 3.3V Regulator

More results

同様の説明 - SI-3006KWM

メーカー	部品番号	データシート	部品情報
Sanken electric	SI-3003KWM	369Kb / 9P	1 A, Low-Dropout, Dual Output, 1.8 V & 2.5 V Regulator
Allegro MicroSystems	SI-3002KWF	261Kb / 6P	1 A, Low-Dropout, Dual Output, 2.5 V & 3.3 V Regulator
	SI-3002KWD	440Kb / 9P	1 A, Low-Dropout, Dual Output, 2.5 V & 3.3 V Regulator
	SI-3002KWM	368Kb / 9P	1 A, Low-Dropout, Dual Output, 2.5 V & 3.3 V Regulator
	SI-3018KM	371Kb / 9P	1 A, Low-Dropout, 1.8 V Regulator
	SI-3033KM	330Kb / 9P	1 A, Low-Dropout, 3.3 V Regulator
	SI-3010LLSL	1Mb / 9P	1.5 A, Ultra-Low-Dropout, 1~3.3 V Regulator
Toshiba Semiconductor	TA48018F	265Kb / 12P	1.8 V, 2 V, 2.5 V, 3 V, 3.3 V, 5 V Three-Terminal Low Dropout Voltage Regulator with Output Current of 1 A
Toshiba Semiconductor	TA48018F	298Kb / 12P	1.8 V, 2 V, 2.5 V, 3 V, 3.3 V, 5 V Three-Terminal Low Dropout Voltage Regulator with Output Current of 1 A
Texas Instruments	LM3940	1Mb / 24P	[Old version datasheet] LM3940 1-A Low-Dropout Regulator for 5-V to 3.3-V Conversion