SS-L CS-2461 10/21/04

Page 1 of 4

Features

• Advanced laser light source and

patented optical design.

• Sleek low-profile housing (1.66"/

42.164 mm height).

• Sensitivity to 0.03%/foot.

• Rotary DECADE address

switches. Set 01 – 99.

• Dual bi-color (red/green) LEDs

flash green when Normal and are

steady red in Alarm.

• Compatible with the 602, 610,

632, 654 and 658 with

SmartScan™ SLC.

• Dual LED design provides 360°

viewing angle.

• Built-in magnetic test switch, or

automatic test commanded from

panel.

• Optional relay, isolator, or

sounder bases.

Listings

Listings and approvals below

apply to the SS-L Laser Smoke

Detector. In some cases, certain

modules may not be listed by

certain approval agencies, or

listing may be in process.

Consult factory for latest listing

status.

• UL Listed: file S1195.

SS-L

Laser Smoke Detector

Description

SS-L Laser Detector pro-

vides a revolutionary ad-

vance in early warning

smoke detection technol-

ogy. The unique design of

this detector, combined

with enhanced algorithms

in the Gamewell — control

panels, allows smoke de-

tection sensitivity that is 10

to 50 times higher than

present photoelectric tech-

nology. Because of this

high sensitivity, the SS-L

can provide very early

warning of slow smoldering

fires. Its performance is

comparable to present as-

piration technology, at a

substantially lower in-

stalled cost.

The SS-L uses an ex-

tremely bright laser diode,

combined with special lens

and mirror optics (U.S.

patent pending), to achieve

a signal-to-noise ratio that

is much higher than tradi-

tional photoelectric sensors. In addition, the tightly focused light beam, com-

bined with algorithms, allow the system to differentiate between dust and smoke

particles. Because of this differentiation, the SS-L can be set to extremely high

sensitivity, yet can reject false signals caused by larger airborne particles such

as dust, lint, and small insects (U.S. patents pending).

Installation

The SS-L plug-in detector uses a separate base to simplify installation, service,

and maintenance. A special tool allows maintenance personnel to plug-in and re-

move detectors without using a ladder.

Mount base on a box which is at least 1.5" (38.1 mm) deep. Suitable mounting

base boxes include:

• 4" (101.6 mm) square box.

• 3-1/2" (88.9 mm) or 4" (101.6 mm) octagonal box.

• Single-gang box (except relay or isolator base).

SS-L with SS-B6 base (top), B501 base (middle),

and RMK400 recessed mounting kit (bottom).

5306p1.jpg