Instruction Sheet

Connector- Specific Kit 679167- 1 for

408--9872

LOC B

1

of 3

E

2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company

All Rights Reserved

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.

*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.

TOOLING ASSISTANCE CENTER 1--800--722--1111

PRODUCT INFORMATION 1--800--522--6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com

18 Mar 11 Rev E

AMP- LATCH* System 50 Receptacle Connectors

Figure 1

Connector-Specific Kit

Lower Insert

Locators

Upper Tool

Cable Stop

Typical Application

Manual Arbor Frame

Assembly 91085--2 (Ref)

Base Assembly Universal

Arbor Tool 768338--2

Guard (Ref)

1. INTRODUCTION

This instruction sheet covers the installation and

setup procedures for Connector--Specific Kit

679167--1. The connector--specific kit is used with

Base Assembly Universal Arbor Tool 768338--2

(408--9875) and Manual Arbor Frame Assembly

91085--2 (408--7777) (shown in Figure 1) or

Pneumatic Auto--Cycle Unit 91112--3 (408--6732) to

terminate AMP--LATCH System 50 receptacle

connectors onto cable.

Refer to instruction sheets (given in parenthesis)

supplied with the tool for tooling information. For

information on AMP--LATCH connectors, contact

PRODUCT INFORMATION at the number at the

bottom of this page.

Reasons for reissue of this instruction sheet are

provided in Section 6, REVISION SUMMARY.

Dimensions in this instruction sheet are in

millimeters [followed by inches in brackets].

The connector--specific kit consists of an upper tool, a

lower insert, two locators, and a cable stop. The

upper tool is secured to the upper tool mount and

applies an even force over the length of the connector

during termination. The locators and the lower insert

properly align the connector for termination.

3. CABLE REQUIREMENT

The receptacle connectors accept 0.64 [.025]

centerline ribbon cable with solid or stranded

conductors size 30 AWG or stranded conductors size

32 AWG (7 strands/40 AWG). Refer to Figure 2 for

recommended cable dimensions.

NOTE

i