L6238SQA datasheet(9/31 Pages) STMICROELECTRONICS

部品番号	L6238SQA

部品情報	12V SENSORLESS SPINDLE MOTOR CONTROLLER

Download	31 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

9 / 31 page

used in an application, it may either be connected

to ground or VLOGIC as required, It may also be

simply left unconnected.

If no connection is made, the pin is either pulled

high or low by internal constant current gener-

ators as shown above.

A listing of the logic and clock inputs is shown in

Table 1 with the corresponding default state.

1.3 Modes of Operation

There are 5 basic modes of operation.

1) Tristate

When Output Enable is low, the output power

drivers are tristated.

2) Start-Up

With Output Enable high, bringing Run/Brake

from a low to a high will energize the motor and

the system will be driven by the Fully-Integrated

StartUp Algorithm.

A user-defined Start-Up Algorithm, under control

of a MicroProcessor, can also be achieved via the

sequence increment input.

3) Run

Run mode is achieved when the motor speed

(controlled

by

the

external

microprocessor)

reaches the nominal speed.

4) Park

When Run/Brake is brought low, energy to park

the heads may be derived from the rectified Bemf.

The energy recovery time is a function of the

Brake Delay Time Constant. In this state, the qui-

escent current of the device is minimized (sleep

mode).

5) Brake

After the Energy Recovery Time-Out, the device

is in Brake, with all lower Drivers in full conduc-

tion.

There are two mutually exclusive conditions

which may be present during the Tristate Mode

(wake up):

a)the spindle is stopped.

b)the system is still running at a speed that

allows for resynchronization.

In order to minimize the ramp up time, the micro-

controller has the possibility to:

check the SPIN SENSE pin, (which toggles at

the Bemf zero crossing frequency)

enable the power to the motor based on the

previous information. Otherwise the

µP may is-

sue a Brake command, followed by the start-

up procedure after the motor has stopped spin-

ning.

2.0 STATE DIAGRAMS

2.1 State Diagram

Figure 2-1 is a complete State Diagram of the

controller depicting the operational flow as a func-

tion of the control pins and motor status. The flow

can be separated into four distinct operations.

2.2 Align + Go

Figure 2-2 represent the normal flow that will

achieve a spin-up of the spindle motor using the

internally generated start up algorithm.

Upon

power

up,

or

from

any

state

with

Run/Brake low the controller first sets the state

machine for State=1 with the Outputs Tristated.

The period counter that monitors the time be-

tween zero crossing is stopped, analog with the

phase and mask delay counters.

When Run/Brake is brought high, the motor is in

the first part of the align mode at State 2 (Output

A high and Output C low). If Output Enable is

high, the controller first checks to determine if the

motor is still spinning for a time of 21

Ω (with

Sys_Clk = 10MHz). The drivers are now enabled

and after the align time-out, (64/Falign), the se-

quencer double increments the outputs to State 4

(Output B high and Output A low). The first part

of this align mode is used to reduce the effects of

stiction

Pin Function

Configuration

Tdly (0,1,2)

Pull-Down

Select Pole

Pull-Down

PWM/Linear

Pull-Down

Output Enable

Pull-Down

Run/Brake

Pull-Up

Sequence Increment

Pull-Down

System Clock

Pull-Up

Faling

Pull-Up

Table 1

330

VLOGIC

10

µA

330

VLOGIC

10

µA

PULL-UP

PULL-DOWN

D95IN279

Figure 1-2

L6238S

9/31

同様の部品番号 - L6238SQA

メーカー	部品番号	データシート	部品情報
STMicroelectronics	L6238	402Kb / 35P	SENSORLESS SPINDLE MOTOR CONTROLLER

More results

同様の説明 - L6238SQA

メーカー	部品番号	データシート	部品情報
STMicroelectronics	L6238	402Kb / 35P	SENSORLESS SPINDLE MOTOR CONTROLLER
Micro Linear Corporatio...	ML4411	296Kb / 14P	Sensorless Spindle Motor Controller
Rohm	BA6966FV	182Kb / 6P	1ch Sensorless Spindle Motor Driver for MD
Fairchild Semiconductor	ML4425	167Kb / 16P	Sensorless BLDC Motor Controller
Micro Linear Corporatio...	ML4425	353Kb / 16P	Sensorless BLDC Motor Controller
Micro Linear Corporatio...	ML4435	576Kb / 14P	Sensorless BLDC Motor Controller
Fairchild Semiconductor	FAN8620B	475Kb / 35P	12V Spindle Motor and Voice Coil Motor Driver
	KA2811C	313Kb / 28P	12V Spindle Motor and Voice Coil Motor Driver
	FAN8621B	228Kb / 21P	12V Spindle Motor and Voice Coil Motor Driver IC
Micro Linear Corporatio...	ML4420	2Mb / 14P	ENHANCED SENSORLESS BLDC MOTOR CONTROLLER