TDA9207 datasheet(7/22 Pages) STMICROELECTRONICS

部品番号	TDA9207

部品情報	150 MHz PIXEL VIDEO CONTROLLER FOR MONITORS INCLUDING CUT-OFF INPUTS

Download	22 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

7 / 22 page

TDA9207

7/22

Figure 4. Waveforms (Drive adjustment)

4.10 Bandwidth Adjustment

A new feature: Bandwidth adjustment, has been

implemented on the TDA9207.

This function has several advantages:

– Depending on the external capacitive load and

on the peak-to-peak output voltage, the band-

width can be adjusted to avoid any slew-rate

phenomenon.

– The preamp bandwidth can be adjusted in order

to reduce electromagnetic radiation, since it is

possible to slow down the signal rise/fall time at

the CRT driver input without too much affecting

the rise/fall time at the CRT driver output.

– It is possible to optimize the ratio of the frequen-

cy response versus the CRT driver power con-

sumption for any kind of chassis, as the preamp

bandwidth adjustment also allows the adjust-

ment of the rise/fall time on the cathode (through

the CRT driver).

– In still picture mode, when a high Video swing

voltage is of greater interest than rise/fall time,

bandwidth adjustment is used to avoid any slew-

rate phenomenon at the CRT driver output and to

meet electromagnetic radiation requirements.

4.11 CRT Cathode Coupling

The powerfull multiplex capability of the TDA9207

allows to use the device with several kinds of CRT

cathode coupling.

4.11.1 AC coupling with DC restore ( Figure 5)

In this mode the output DC level (VDC) is adjusted

simultaneously for the 3 channels from 0.5 V to

2.35 V via Register 6 (4 bits). The cut-off voltage is

programmed independently for each channel from

0.17 V to 4.6 V using registers 10, 11, 12 (8 bits

each, see I2C Table 1).

HSYNC

BPCP

BLK

Video IN

BFLK

OSD IN

VCONT

Two examples of drive

adjustment (1)

VBLACK

VDC

VBRT

VOSD

VOUT1,VOUT2,VOUT3

Note :

1.Drive adjustment modifies the following voltages : VCONT,VBRT and VOSD.

Drive adjustment doesn’t modify the following voltages : VDC and VBLACK.

同様の部品番号 - TDA9207

メーカー	部品番号	データシート	部品情報
STMicroelectronics	TDA9201	709Kb / 12P	WIDE BAND VIDEO PREAMPLIFIER
	TDA9203	119Kb / 13P	I2C BUS CONTROLLED 70MHz RGB PREAMPLIFIER
	TDA9203A	119Kb / 13P	I2C BUS CONTROLLED 70MHz RGB PREAMPLIFIER
	TDA9206	127Kb / 12P	I2C BUS CONTROLLED 130MHz RGB PREAMPLIFIER
	TDA9209	268Kb / 22P	150 MHz PIXEL VIDEO CONTROLLER FOR MONITORS INCLUDING CUT-OFF INPUTS AND VIDEO DETECTION

More results

同様の説明 - TDA9207

メーカー	部品番号	データシート	部品情報
STMicroelectronics	TDA9209	268Kb / 22P	150 MHz PIXEL VIDEO CONTROLLER FOR MONITORS INCLUDING CUT-OFF INPUTS AND VIDEO DETECTION
	TDA9210	206Kb / 19P	150 MHz PIXEL VIDEO CONTROLLER FOR MONITORS
	STV9211	680Kb / 37P	150 MHz PIXEL VIDEO CONTROLLER FOR MONITORS IN DC-COUPLING MODE
NXP Semiconductors	TDA4885	396Kb / 56P	150 MHz video controller with I2C-bus 1997 Nov 25
List of Unclassifed Man...	TDA19989BET	51Kb / 1P	150 MHz pixel rate HDMI 1.4 transmitter with 3 x 8 -bit video inputs and CEC support
NXP Semiconductors	TDA9989	238Kb / 48P	150 MHz pixel rate HDMI 1.3a transmitter with 3 쨈 8-bit video inputs and CEC support Rev. 02-11 June 2009
	TDA19989	349Kb / 47P	150 MHz pixel rate HDMI 1.3 transmitter with 3 횞 8-bit video inputs, HDCP and CEC support Rev. 01-15 February 2010
	TDA4686	145Kb / 28P	Video processor with automatic cut-off control 1997 Jun 23
Axiomtek Co., Ltd.	P6105	306Kb / 2P	Multiple video inputs including DVI-D and HDMI
NXP Semiconductors	TDA4687	129Kb / 24P	Video processor with automatic cut-off control 1997 Jun 23