SS6639-27CZBG datasheet(8/12 Pages) SSC

部品番号	SS6639-27CZBG

部品情報	1-Cell, 3-Pin, Step-Up DC/DC Controller

Download	12 Pages

Scroll/Zoom	100%

メーカー	SSC [Silicon Standard Corp.]

ホームページ	http://www.siliconstandard.com

Logo

8 / 12 page

www.SiliconStandard.com

8 of 12

SS6639

n PIN DESCRIPTIONS

Pin 1:

GND:

Ground. Must be low impedance;

solder directly to ground plane.

Pin 2:

VOUT:

IC supply pin. Connect Vout to the

regular output.

Pin 3:

EXT:

Push-pull driver output for external

power. Switch.

n APPLICATION INFORMATION

General Description

The SS6639 PFM (pulse frequency modulation)

controller IC combines a switch mode regulator, a

push-pull driver, a precision voltage reference, and a

voltage detector in a single monolithic device. It

offers

extremely

low

quiescent

current,

high

efficiency, and very low gate-threshold voltage to

ensure start-up with low battery voltage (0.8V typ.).

Designed to maximize battery life in portable

products, it minimizes switching losses by only

switching as needed to service the load.

PFM controllers transfer a discrete amount of energy

per cycle and regulate the output voltage by

modulating the switching frequency with a constant

turn-on time. Switching frequency depends on load,

input voltage, and inductor value and can range up

to 100 KHz.

When the output voltage drops, the error comparator

enables the 100 kHz oscillator which turns the

MOSFET on for around 7.5us and off for 2.5

µs.

Turning on the MOSFET allows inductor current to

ramp up, storing energy in the magnetic field.

When the MOSFET turns off, the inductor forces

current through the diode to the output capacitor and

the load. As the stored energy is depleted, the

current ramps down until the diode turns off. At this

point, the inductor may ring due to residual energy

and stray capacitance. The output capacitor stores

charge when current flowing through the diode is

high, and releases it when current is low, thereby

maintaining a steady voltage across the load.

As

the

load

increases,

the

output

capacitor

discharges faster and the error comparator initiates

cycles sooner, increasing the switching frequency.

The maximum duty cycle ensures adequate time for

energy transfer to the output during the second half

of each cycle. Depending on the circuit, PFM

controllers can operate in either discontinuous mode

or continuous conduction mode. The continuous

conduction mode means that the inductor current

does not ramp to zero during each cycle.

+

V

IN

SW

V

OUT

EXT

I

D

I

OUT

Isw

Ico

I

IN

Discontinuous Conduction Mode

Rev.2.01 6/26/2003

同様の部品番号 - SS6639-27CZBG

メーカー	部品番号	データシート	部品情報
Silicon Standard Corp.	SS6630	616Kb / 13P	Step-Up DC/DC Controller
	SS6630-3CNTB	616Kb / 13P	Step-Up DC/DC Controller
	SS6630-3CNTR	616Kb / 13P	Step-Up DC/DC Controller
	SS6630-3CSTB	616Kb / 13P	Step-Up DC/DC Controller
	SS6630-3CSTR	616Kb / 13P	Step-Up DC/DC Controller

More results

同様の説明 - SS6639-27CZBG

メーカー	部品番号	データシート	部品情報
Analog Intergrations Co...	AIC1639	147Kb / 11P	3-PIN ONE-CELL STEP-UP DC/DC CONVERTER
	AIC1638	240Kb / 15P	3-PIN ONE-CELL STEP-UP DC/DC CONVERTER
	AIC1642	251Kb / 14P	3-Pin One-Cell Step-Up DC/DC Converter
	AIC1630	374Kb / 11P	2-Cell, Step-Up DC/DC Converter Controller
Maxim Integrated Produc...	MAX848	166Kb / 16P	1-Cell to 3-Cell, High-Power, Low-Noise, Step-Up DC-DC Converters Rev 2; 12/97
Analog Intergrations Co...	AIC1628	259Kb / 7P	3-Cell, High-Efficiency, Step-Up DC/DC Converter
RICOH electronics devic...	R1211N002A	512Kb / 40P	STEP-UP DC/DC CONTROLLER
RICOH electronics devic...	R1211X	375Kb / 33P	Step-up DC/DC Controller
E-CMOS Corporation	EC9215	1Mb / 15P	Step-up DC/DC Controller
Silicon Standard Corp.	SS6630	616Kb / 13P	Step-Up DC/DC Controller