LMR10515

www.ti.com

SNVS728C – OCTOBER 2011 – REVISED APRIL 2013

PIN DESCRIPTIONS 5-Pin SOT-23

Pin

Name

Function

1

SW

Switch node. Connect to the inductor and catch diode.

2

GND

Signal and power ground pin. Place the bottom resistor of the feedback network as close as possible

to this pin.

3

FB

Feedback pin. Connect to external resistor divider to set output voltage.

4

EN

Enable control input. Logic high enables operation. Do not allow this pin to float or be greater than VIN

+ 0.3V.

5

VIN

Input supply voltage.

PIN DESCRIPTIONS 6-Pin WSON

Pin

Name

Function

1

FB

Feedback pin. Connect to external resistor divider to set output voltage.

2

GND

Signal and power ground pin. Place the bottom resistor of the feedback network as close as

possible to this pin.

3

SW

Switch node. Connect to the inductor and catch diode.

4

VIND

Power Input supply.

5

VINA

Control circuitry supply voltage. Connect VINA to VIND on PC board.

6

EN

Enable control input. Logic high enables operation. Do not allow this pin to float or be greater than

VINA + 0.3V.

DAP

Die Attach Pad

Connect to system ground for low thermal impedance, but it cannot be used as a primary GND

connection.

These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam

during storage or handling to prevent electrostatic damage to the MOS gates.

Absolute Maximum Ratings

(1) (2)

VIN

-0.5V to 7V

FB Voltage

-0.5V to 3V

EN Voltage

-0.5V to 7V

SW Voltage

-0.5V to 7V

ESD Susceptibility

2kV

150°C

Storage Temperature

−65°C to +150°C

Soldering Information

For soldering specifications: http://www.ti.com/lit/SNOA549C

(1)

Absolute maximum ratings indicate limits beyond which damage to the device may occur. Operating Range indicates conditions for

which the device is intended to be functional, but does not ensure specfic performance limits. For ensured specifications and test

conditions, see the Electrical Characteristics.

(2)

If Military/Aerospace specified devices are required, please contact the Texas Instruments Sales Office/ Distributors for availability and

specifications

(3)

Thermal shutdown will occur if the junction temperature exceeds the maximum junction temperature of the device.

Operating Ratings

VIN

3V to 5.5V

Junction Temperature

−40°C to +125°C

Copyright © 2011–2013, Texas Instruments Incorporated

Submit Documentation Feedback

3

Product Folder Links: LMR10515