STANDARD

MICROCIRCUIT DRAWING

SIZE

A

5962-89647

DEFENSE SUPPLY CENTER COLUMBUS

COLUMBUS, OHIO 43218-3990

REVISION LEVEL

B

SHEET

10

DSCC FORM 2234

APR 97

3.6 Certificate of compliance. A certificate of compliance shall be required from a manufacturer in order to be listed as an

approved source of supply in MIL-HDBK-103 (see 6.6 herein). The certificate of compliance submitted to DSCC-VA prior to

listing as an approved source of supply shall affirm that the manufacturer's product meets the requirements of MIL-PRF-38535,

appendix A and the requirements herein.

3.7 Certificate of conformance. A certificate of conformance as required in MIL-PRF-38535, appendix A shall be provided

with each lot of microcircuits delivered to this drawing.

3.8 Notification of change. Notification of change to DSCC-VA shall be required for any change that affects this drawing.

3.9 Verification and review. DSCC, DSCC's agent, and the acquiring activity retain the option to review the manufacturer's

facility and applicable required documentation. Offshore documentation shall be made available onshore at the option of the

reviewer.

4. VERIFICATION

4.1 Sampling and inspection. Sampling and inspection procedures shall be in accordance with MIL-PRF-38535,

appendix A.

4.2 Screening. Screening shall be in accordance with method 5004 of MIL-STD-883, and shall be conducted on all devices

prior to quality conformance inspection. The following additional criteria shall apply:

a.

Burn-in test, method 1015 of MIL-STD-883.

(1) Test condition B. The test circuit shall be maintained by the manufacturer under document revision level control

and shall be made available to the preparing or acquiring activity upon request. The test circuit shall specify the

inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in method 1015

of MIL-STD-883.

b.

Interim and final electrical test parameters shall be as specified in table II herein, except interim electrical parameter

tests prior to burn-in are optional at the discretion of the manufacturer.

4.3 Quality conformance inspection. Quality conformance inspection shall be in accordance with method 5005 of MIL-STD-

883 including groups A, B, C, and D inspections. The following additional criteria shall apply.

4.3.1 Group A inspection.

a.

Tests shall be as specified in table II herein.

b.

Subgroups 7, 8, 9, 10, and 11 in table I, method 5005 of MIL-STD-883 shall be omitted.

4.3.2 Groups C and D inspections.

a.

End-point electrical parameters shall be as specified in table II herein.

b.

Steady-state life test conditions, method 1005 of MIL-STD-883.

(1)

Test condition B. The test circuit shall be maintained by the manufacturer under document revision level control

and shall be made available to the preparing or acquiring activity upon request. The test circuit shall specify the

inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in method

1005 of MIL-STD-883.

(2)

(3)

Test duration: 1,000 hours, except as permitted by method 1005 of MIL-STD-883.