LM1971

SNAS104B – FEBRUARY 1995 – REVISED APRIL 2013

www.ti.com

Connection Diagram

Figure 2. Dual-In-Line Plastic or Surface Mount Package- Top View

These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam

during storage or handling to prevent electrostatic damage to the MOS gates.

Absolute Maximum Ratings

(1) (2) (3)

15V

Voltage at any pin

(GND

3000V

Soldering Information

P Package (10s)

260°C

D Package

Vapor Phase (60s)

215°C

Infrared (15s)

220°C

150 mW

Junction Temperature

150°C

Storage Temperature

−65°C to +150°C

(1)

All voltages are measured with respect to the GND pin (pin 3), unless otherwise specified.

(2)

Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for

which the device is functional, but do not specify specific performance limits. Electrical Characteristics state DC and AC electrical

specifications under particular test conditions which ensure specific performance limits. This assumes that the device is within the

Operating Ratings. Specifications are not ensured for parameters where no limit is given, however, the typical value is a good indication

of device performance.

(3)

If Military/Aerospace specified devices are required, please contact the Texas Instruments Sales Office/ Distributors for availability and

specifications.

(4)

Human body model, 100 pF discharged through a 1.5 k

Ω resistor.

(5)

board mounted is 102° C/W and 167° C/W, respectively.

Operating Ratings

(1) (2)

Temperature Range

D0008A Package,

167°C/W

Thermal Resistance

P0008E Package,

102°C/W

Supply Voltage

4.5V to 12V

(1)

Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for

which the device is functional, but do not specify specific performance limits. Electrical Characteristics state DC and AC electrical

specifications under particular test conditions which ensure specific performance limits. This assumes that the device is within the

Operating Ratings. Specifications are not ensured for parameters where no limit is given, however, the typical value is a good indication

of device performance.

(2)

All voltages are measured with respect to the GND pin (pin 3), unless otherwise specified.

2

Submit Documentation Feedback

Copyright © 1995–2013, Texas Instruments Incorporated

Product Folder Links: LM1971