FC80960HD66SL2GN datasheet(10/102 Pages) INTEL

部品番号	FC80960HD66SL2GN

部品情報	80960HA/HD/HT 32-Bit High-Performance Superscalar Processor

Download	102 Pages

Scroll/Zoom	100%

メーカー	INTEL [Intel Corporation]

ホームページ	http://www.intel.com

Logo

10 / 102 page

80960HA/HD/HT

4

Advance Information Datasheet

2.2.6

Dual Programmable Timers

The processor provides two independent 32-bit timers, with four programmable clock rates. The

user configures the timers via the Timer Unit registers. These registers are memory-mapped within

the 80960Hx, addressable on 32-bit boundaries. The timers have a single-shot mode and

auto-reload capabilities for continuous operation. Each timer has an independent interrupt request

to the processor’s interrupt controller.

2.2.7

Processor Self Test

When a system error is detected, the FAIL pin is asserted, a fail code message is driven onto the

address bus, and the processor stops execution at the point of failure. The only way to resume

normal operation is to perform a RESET operation. Because System Error generation can occur

sometime after the bus confidence test and even after initialization during normal processor

operation, the FAIL pin is HIGH (logic “1”) before the detection of a System Error.

The processor uses only one read bus-transaction to signal the fail code message; the address of the

bus transaction is the fail code itself. The fail code is of the form: 0xfeffffnn; bits 6 to 0 contain a

mask recording the possible failures. Bit 7, when set to 1, indicates that the mask contains failures

from the internal Built-In Self-Test (BIST); when 0, the mask indicates other failures.

Ignore reserved bits 0 and 1. Also ignore bits 5 and 6 when bit 7 is clear (=0).

The mask is shown in Table 2 and Table 3.

Table 2.

Fail Codes For BIST (bit 7 = 1)

Bit

When Set:

6

On-chip Data-RAM failure detected by BIST.

5

Internal Microcode ROM failure detected by BIST.

4

Instruction cache failure detected by BIST.

3

Data cache failure detected by BIST.

2

Local-register cache or processor core failure detected by BIST.

1

Reserved. Always zero.

0

Reserved. Always zero.

Table 3.

Remaining Fail Codes (bit 7 = 0)

Bit

When Set:

6

Reserved. Always one.

5

Reserved. Always one.

4

A data structure within the IMI is not aligned to a word boundary.

3

A System Error during normal operation has occurred.

2

The Bus Confidence test has failed.

1

Reserved. Always zero.

0

Reserved. Always zero.

同様の部品番号 - FC80960HD66SL2GN

メーカー	部品番号	データシート	部品情報
Sanyo Semicon Device	FC809	50Kb / 2P	30V, 70mA Rectifier

More results

同様の説明 - FC80960HD66SL2GN

メーカー	部品番号	データシート	部品情報
Intel Corporation	80960CF-30	1Mb / 62P	SPECIAL ENVIRONMENT 80960CF-30, -25, -16 32-BIT HIGH-PERFORMANCE SUPERSCALAR PROCESSOR
Silicon Laboratories	EFM32GG232	1Mb / 71P	High Performance 32-bit processor
Freescale Semiconductor...	MC68060RC50	86Kb / 10P	Superscalar 32-Bit Microprocessors
Intel Corporation	A80960CF33	1Mb / 70P	80960CF-40, -33, -25 32-Bit High-Performance Superscalar Embedded Microprocessor
	80960CF-40	1Mb / 77P	80960CF-40, -33, -25, -16 32-BIT HIGH-PERFORMANCE SUPERSCALAR EMBEDDED MICROPROCESSOR
	376	1Mb / 95P	376TM HIGH PERFORMANCE 32-BIT EMBEDDED PROCESSOR
STMicroelectronics	STLS2F01	679Kb / 48P	Loongson 2F: High performance 64-bit superscalar MIPS짰 microprocessor
STMicroelectronics	STLS2F02	725Kb / 49P	Loongson 2F high performance 64-bit superscalar MIPS짰 microprocessor
List of Unclassifed Man...	EFM32GG332F512	1Mb / 67P	High Performance 32-bit processor @ up to 48 MHz
List of Unclassifed Man...	EFM32GG230	3Mb / 66P	High Performance 32-bit processor up to 48 MHz