データシートサーチシステム
  Japanese  ▼
ALLDATASHEET.JP

X  

LM1279N データシート(PDF) 9 Page - National Semiconductor (TI)

[Old version datasheet] Texas Instruments acquired National semiconductor.
部品番号 LM1279N
部品情報  110 MHz RGB Video Amplifier System with OSD
Download  14 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
メーカー  NSC [National Semiconductor (TI)]
ホームページ  http://www.national.com
Logo NSC - National Semiconductor (TI)

LM1279N データシート(HTML) 9 Page - National Semiconductor (TI)

Back Button LM1279N Datasheet HTML 5Page - National Semiconductor (TI) LM1279N Datasheet HTML 6Page - National Semiconductor (TI) LM1279N Datasheet HTML 7Page - National Semiconductor (TI) LM1279N Datasheet HTML 8Page - National Semiconductor (TI) LM1279N Datasheet HTML 9Page - National Semiconductor (TI) LM1279N Datasheet HTML 10Page - National Semiconductor (TI) LM1279N Datasheet HTML 11Page - National Semiconductor (TI) LM1279N Datasheet HTML 12Page - National Semiconductor (TI) LM1279N Datasheet HTML 13Page - National Semiconductor (TI) Next Button
Zoom Inzoom in Zoom Outzoom out
 9 / 14 page
background image
Applications of the LM1279 (Continued)
age surges that may result during the power up and power
down modes, or when connecting the monitor to other equip-
ment. The monitor designer must include these resistors in
his design for good monitor reliability. If additional protection
against ESD at the video inputs is necessary, then adding
clamp diodes on the IC side of the 30
Ω resistors is recom-
mended, one to V
CC1 and one to ground (see Figure 6).
Sometimes a designer may want to increase the value of the
30
Ω resistors at the video inputs, for additional ESD protec-
tion. This is not recommended with the LM1279. C5, C7, and
C9 are part of the DC restoration circuit. This circuit is de-
pending on a total maximum circuit resistance of about
110
Ω;30Ω input series resistor plus 75Ω for the video termi-
nation resistor. Increasing the value of the 30
Ω resistors will
exceed the 110
Ω limit. The excellent internal ESD protection
and the external clamp diodes (if needed) will provide excel-
lent ESD protection.
The 30
Ω resistors in series with the OSD inputs are also
necessary if the OSD signals are external to the monitor, or
if these signals are present any time when the +8V is not
fully powered up. Interfacing to the OSD inputs is quite easy
since the signal processing necessary to match the OSD sig-
nals to the video levels is done internal by the LM1279.
There is also no need for an OSD window signal. Any time
there is a high TTL signal at any of the three OSD inputs, the
LM1279 will automatically switch to the OSD mode. A high
TTL OSD signal will give a high video output for that color.
The OSD level is fixed, typically 2.3V above the video black
level. This will give a fixed brightness to the OSD window,
but not at maximum video brightness which could be un-
pleasant to the user.
Figure 2 and Figure 3 show the timing
diagrams of the OSD signals for the LM1279.
The recommended load impedance for the LM1279 is 390
Ω.
However, some changes in the load impedance can be
made. If the load impedance is reduced, the monitor de-
signer must confirm that the part is still operating in its proper
die temperature range, never exceeding a die temperature
of 150˚C. When changing the load impedance, the black
level shift is shown in the chart below. The measured V
P-P
output with under 1% distortion is also listed.
Load
V
P-P
Blk. Level Shift
430
3.62V
+15 mV
390
3.62V
0 mV
330
3.58V
−25 mV
270
3.51V
−45 mV
When using a lower load impedance, the LM1279 does go
into hard clipping more quickly. This does reduce the head-
room of the video output.
Board layout is always critical in a high frequency application
such as using the LM1279. A poor layout can result in ringing
of the video waveform after sudden transitions, or the part
could actually oscillate. A good ground plane and proper
routing of the +8V are important steps to a good PCB layout.
The LM1279 does require very good coupling between V
CC1
and V
CC2 (pins 2 and 16). This is clearly shown in Figure 7
and
Figure 11 with the short and large trace between pins 2
and 16. Both demonstration boards offer the monitor de-
signer an excellent example of good ground plane being
used with the LM1279. These boards are single sided, yet al-
low the LM1279 to operate at its peak performance. The
neck board also shows a good example of interfacing to a
CRT driver and to the CRT. The video signal path is kept as
short as possible between the LM1279 and the CRT driver,
and also between the CRT driver and the CRT socket. Actual
performance of the LM1279 in the video pre-amp demon-
stration board is shown in
Figure 8 and Figure 9.
References
Ott, Henry W.
Noise Reduction Techniques in Electronic
Systems, John Wiley & Sons, New York, 1976
Zahid Rahim, “Guide to CRT Video Design,” Application
Note 861, National Semiconductor Corp., Jan. 1993
www.national.com
9


同様の部品番号 - LM1279N

メーカー部品番号データシート部品情報
logo
Texas Instruments
LM1279 TI1-LM1279 Datasheet
798Kb / 20P
[Old version datasheet]   110 MHz RGB Video Amplifier System with OSD
LM1279A TI1-LM1279A Datasheet
556Kb / 15P
[Old version datasheet]   LM1279A 110 MHz RGB Video Amplifier System with OSD
More results

同様の説明 - LM1279N

メーカー部品番号データシート部品情報
logo
Texas Instruments
LM1279 TI1-LM1279 Datasheet
798Kb / 20P
[Old version datasheet]   110 MHz RGB Video Amplifier System with OSD
LM1279A TI1-LM1279A Datasheet
556Kb / 15P
[Old version datasheet]   LM1279A 110 MHz RGB Video Amplifier System with OSD
logo
National Semiconductor ...
LM1269 NSC-LM1269 Datasheet
1Mb / 20P
   110 MHz I2C Compatible RGB Video Amplifier System with OSD & DACs
LM1282 NSC-LM1282 Datasheet
488Kb / 14P
   110 MHz RGB Video Amplifier System with On Screen Display (OSD)
logo
ADDtek Corp
AMC8213 ADDTEK-AMC8213 Datasheet
206Kb / 9P
   200MHz RGB VIDEO AMPLIFIER SYSTEM WITH OSD
JUNE 2006
logo
National Semiconductor ...
LM1283 NSC-LM1283 Datasheet
401Kb / 13P
   140 MHz RGB Video Amplifier System with On Screen Display (OSD)
LM1281 NSC-LM1281 Datasheet
391Kb / 14P
   85 MHz RGB Video Amplifier System with On Screen Display (OSD)
logo
Mitsumi Electronics, Co...
MM1381 MITSUMI-MM1381 Datasheet
268Kb / 10P
   RGB Video Amplifier with OSD Input
logo
National Semiconductor ...
LM1267 NSC-LM1267 Datasheet
1Mb / 20P
   150 MHz I2C Compatible RGB Video Amplifier System with OSD and DACs
LM1262 NSC-LM1262 Datasheet
1Mb / 20P
   200 MHz I2C Compatible RGB Video Amplifier System with OSD and DACs
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14


データシート ダウンロード

Go To PDF Page


リンク URL




プライバシーポリシー
ALLDATASHEET.JP
ALLDATASHEETはお客様のビジネスに役立ちますか?  [ DONATE ] 

Alldatasheetは   |   広告   |   お問い合わせ   |   プライバシーポリシー   |   リンク交換   |   メーカーリスト
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com